Compustar Remote Starter Installation Guide

Compustar Remote Starter Installation Guide

Compustar Remote Starter Installation Guide. Files are available in pdf format. That being said, we recently did a poll among our authorized compustar dealers.

Compustar Remote Starter Installation GuideCompustar Remote Starter Installation Guide
About Remote Starters Compustar from www.compustar.com

Depending on the type of remote starter and remote start accessories you have installed in your vehicle, some remotes might be better for you than others. (or if the remotes are already programmed to the vehicle, press and hold the start button of the remote for 2.5 seconds.) wait, led 2 will ß ash green. Set the vehicle to the ignition or “on” position step 2:

(See The Module Diagnostics Page) Release The Brake Pedal.

This connection simulates the electronic signal produced by the clutch pedal, normally a ground signal sent to the vehicle’s ignition system. Press and release the moduleõs programming button. Press and hold the foot brake step 3.

That Being Said, We Recently Did A Poll Among Our Authorized Compustar Dealers.

Within 5 seconds push to the “off” position When you purchase a new remote, whether you’re looking for a direct replacement or an upgrade, you can begin by reviewing which features you need to control. While holding the foot brake, hold the remote start button on the remote for 2.5 seconds

Compustar Remote Starter Cm4200Dx Install Manual (4 Pages, 0.44 Mb) Compustar Remote Start Systems Are Developed In Anchorage, Alaska So They Know How To Produce A Reliable Remote Start!

(or if the remotes are already programmed to the vehicle, press and hold the start button of the remote for 2.5 seconds.) wait, led 2 will ß ash green. While holding the foot brake, hold the remote start button on the remote for 2.5 seconds there are certain features listed in this manual that may not be. Download compustar user manuals for your compustar remote car starter or security alarm system.

Files Are Available In Pdf Format.

Start the vehicle with the key and allow it to idle down step 2. Pts (push to start vehicles) ap plication step 1: The remote will beep and the lcd read “remote menu” to.

Depending On The Type Of Remote Starter And Remote Start Accessories You Have Installed In Your Vehicle, Some Remotes Might Be Better For You Than Others.

You must code remotes to this system before anything will function. Guide to compustar remote features. Because of this, installation times can vary from vehicle to vehicle and installer to installer.

Leave a Reply

Your email address will not be published.